Konfigurasi VLAN Tagging dengan IP Command

Membuat VLAN tagging di interface virbr1 dengan nama dan ID VLAN 100

ip link add link virbr1 name virbr1.100 type vlan id 100
ip link set dev virbr1.100 up

Verifikasi

ip -d link show virbr1.100

10: virbr1.100@virbr1: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state UP mode DEFAULT group default qlen 1000
    link/ether 52:54:00:50:86:8d brd ff:ff:ff:ff:ff:ff promiscuity 0 
    vlan protocol 802.1Q id 100  addrgenmode eui64

Menambahkan IP ke interface VLAN

ip add add 10.10.100.1/24 dev virbr1.100

Verifikasi

ip -d a show virbr1.100

10: virbr1.100@virbr1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP group default qlen 1000
    link/ether 52:54:00:50:86:8d brd ff:ff:ff:ff:ff:ff promiscuity 0 
    vlan protocol 802.1Q id 100  
    inet 10.10.100.1/24 scope global virbr1.100
       valid_lft forever preferred_lft forever
    inet6 fe80::5054:ff:fe50:868d/64 scope link 
       valid_lft forever preferred_lft forever

Hapus VLAN

ip link delete virbr1.100

Catatan: VLAN yang dibuat dengan ip command akan hilang jika sistem shutdown atau restart, jika ingin membuatnya permanen gunakan ifcfg files

Refrensi: 7.4. Configure 802.1Q VLAN Tagging Using the Command Line